What is ignitor and why it is use in Hpmv lamp ?
Answers were Sorted based on User's Feedback
Answer / pammi.kumar@ymail.com
Dear all ignitor is a stater help glowing for hpmv lamp when lamp glow and ignitor disconct the lamp then lamp not off. i do practical this point.
| Is This Answer Correct ? | 8 Yes | 0 No |
how many types of transformer.
the typical output of a solar cell is........
with out colour codeing on conductor how can be find what is r,what is b,what is y phases.....
What type of changeover switch needed to run a load of five 1.5 tonn ACs.
what is through fault?
What is the formulae of Megger value for a A.C.Motor
If the generator will not synchronize, what will you do?
how the 6.6KV motor can be used with 11KV?
how many minutes or seconds taken by the transmission of electrical power from generating end to distributing end?
If we give 2334 A, 540V on Primary side of 1.125 MVA step up transformer, then what will be the Secondary Current, If Secondary Voltage=11 KV?
Why we use series reactor in power system?
9 Answers Cadbury, HEG, Uttam,
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)