Answer Posted / thran
hpmv High pressure mercury vapour lamp... ignitor used for thee chemical reaction that want lot of high voltage pressure after that lamps are glowing! ignitor 3kv volt!..
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
What is the difference between Droop vs Isoch Control?
I am interested to know what does 15 KVA DG set actually means? If I dont know the DG rating, is it possible to identify KW by simply knowing the diesel consumption?
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
Explain how you intend to work under pressure to meet up with deadline target?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
I want to calculate how much capacitor we connect to maintain the unity power factor? Is there any formula? Pls give me the answer
Why you want to join non technical field when you are an engineer?
Why do power lines not short out when they fall into water?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
how can we phase identification in a distribution line,how we recognise that which phase is coming for a house hold connection.help me............
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
we are having 110 Kv,250mA Electrostatic precipitators for coal fired boilers. what will be static voltage and current after discharge and what time it will remain before earthing?
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
why co incidence factor considered in transformer sizing?
