What is the live zero and dead zero
Answers were Sorted based on User's Feedback
Answer / praveen
0 milliamp is dead zero and 4 milliamp is live zero
| Is This Answer Correct ? | 10 Yes | 1 No |
Answer / shibli nomani
Live0-At 0 input ,output has some value e.g at 0 tx has 4mA.
Dead0-At 0 input, output has Also zero.
| Is This Answer Correct ? | 1 Yes | 1 No |
In which principle Woodward Governor 505 work in power plant? What are the input of Woodward governor 505
A pressure Tx accuracy is 0.2%. Signal o/p is 4-20ma.span is 16 Ma.how many deviate the o/p then calibration needed
what is wave length were using ?
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
A temperature sensor (RTD) connected via a temperature transmitter is adjusted to give an output of 4ma at 60 deg and 20 ma at 600 deg. This output (4-20ma) from the transmitter is connected to an IGBT-inverter to control a high speed (-12,000 to +12,000 RPM) DC motor. And in the inverter it is programmed as, for 4ma the motor speed will be -3,000 RPM and for 20ma the motor speed will be +10,000 RPM. The question is : If the motor speed is +5,500 (RPM), what will be the temperature? (-sign indicates that the motion is in reverse direction).
Thermocouple is a transducer but rtd is not transducer why? Both taking heat as a input and giving mv
how to calibate level transmiter ?range -150 to +150.what is the zero and span?
Give me best instrumentation Books name..Ple...
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
If an Instrument has 550 ohm internal resistance and the cable used for that instrument is 0.5 ohm per meter resistance. If the voltage is 12volt.How much length cable can be used? Please tell me its Calculation formula.
can you tell me how many stages in steam turbine of 10 MW power plant
draw shematic diagram of c/v positioner(smart type)?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)