Answer / hassanelect

The internal elements of a valve are collectively referred
to as a valve's trim. The trim typically includes a disk,
seat, stem, and sleeves needed to guide the stem.
A valve's performance is determined by the disk and
seat interface and the relation of the disk position to the
seat. Because of the trim, basic motions and flow
control are possible. In rotational motion trim
designs, the disk slides closely past the seat to
produce a change in flow opening. In linear motion
trim designs, the disk lifts perpendicularly away from the
seat so that an annular orifice appears

Reference:
http://www.tpub.com/content/doe/h1018v2/css/h1018v2_23.htm

What are the difference between mass flow meter, magnetic flow meter and vortex flow meter.

1 Answers  

---

In most process, speed of motor controlled by control system with a reference pot . Now if i start & it becomes uncontrollable, i.e.gets directly start & stop after certain time.Then which reasons can make such problem? can motor may be faulty?how?

3 Answers   Siemens,

---

what is mean by process control?

4 Answers  

---

I am going to attend a recruitment drive by Schneider in 2 weeks. They have a technical test in the beginning. I would like to know what are the areas i should concentrate on while preparing for the test. My major is Electronics and Instrumentation.

1 Answers  

---

What is the Working principle of Dozing valve?

0 Answers   Shree Cement,

---

---

what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.

0 Answers  

---

where cascade loop use ?

0 Answers   KNPC, KOC,

---

how u measure dp in dp tx? how u calibrate a dp tx?

3 Answers   Invensys,

---

What is Integral and Derivative control?

5 Answers   Qatar Petroleums,

---

what is instrumentation?

8 Answers  

---

Explain types of valves?

0 Answers  

---

How to find out turn down ratio of Pressure transmitter?

1 Answers  

---