why we r not earthed Control cable of C.T. terminals

0 Answers   HCC,

---

In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?

0 Answers  

---

What is Meter MF if External CT Ratio is 150/1 , PT Ratio is 132/110 Meter CT Ratio is 200/1 & Meter PT Ratio is 110/1

0 Answers  

---

what is the formular for the calculation of CT'S when installed as part of a electrical installation so the correct meter is used

2 Answers  

---

why 3 phase motors are preferable over single phase motors ?

6 Answers  

---

What the formula for calculating no.of earthings & size of earth strip for 100mX90m shop.

0 Answers  

---

why the excitation is necessary to produce the reactive power

2 Answers  

---

Where r use in Dc motor in power plant?

2 Answers  

---

different between electrical and electronics Engineering????

4 Answers  

---

sir , what happen if we decrease ( approx 3 inch ) the lenth of shaft in 110KW Induction , three phase motor. actually a 110KW motor is couppled with star couplling to 120TR compressor. When we doing maintenance in compressor it is required to skid the motor backword and resulting dis- alightnment . so we want to change the tyre coupling in place of existing coupling. so it is required to cut off the rotor aprox 3 inch form driving side.

2 Answers  

---

which is better to use svc or synchronous condenser why ?

0 Answers  

---

Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.

0 Answers   HAL,

---