What kind of test is conducted commonly for generator? And explain briefly
- 1 Answers
- 4392 Views
- MAHINDRA, I also Faced
- E-Mail Answers
Answer / ranjan
Brake test , regenerative test , running down test are cönducted for generator.
| Is This Answer Correct ? | 2 Yes | 3 No |
why to use 50hz only in tansmisson and as well as in distribution why not60hz?
Define gain margin?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
how the aircraft outer body and inner body is separated ?
in three 3.5 core aluminium ug cable. one cable is used for one phase by shrting R,Y and B wires and other 2 cables used for Y and b phases. balace 3 neutral wires are made common and connected to load. suddenly neutral current was more than line current what is the reason behind this?
how to 2 phase supply from 3 phase
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
how point on wave controller works.
At which time Synchronous generator act as a Synchronous Condenser?
How it can worked plc based electrical system And which type of software using.
how MW increase when steam input increase in turbine.
When can we take Neutral as common neutral link?
-
Civil Engineering (5085) - Mechanical Engineering (4452)
- Electrical Engineering (16638)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
