Answer / bhanu prakash

A frame is the skeleton of a car without the mountings, were as a chasis is a mounted frame.

Or
This two are similar name. In case of four wheeler's passionser vehicles called frame

How to calculate bearing number to diameter of the inner and outer?

0 Answers   GM General Motors,

---

The main disadvantage of sliding mesh type of gear box is a) High noise level b) Low mechanical efficiency c) High skill required by the driver d) all of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What is BHP & How it is measured?

6 Answers   BHP, Maruti Suzuki,

---

The main function of transmission is a) To provide means to vary the torque ratio between the engine and the road wheels b) To provide neutral position c) To provide means to back the car d) all of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What will happen if wrong fuel is burnt in engine?

0 Answers  

---

wat happens if u use petrol in diesel engine

13 Answers   Ashok Leyland, Infosys,

---

State some of kingpin offset application.

0 Answers  

---

prove the relation for the torque required in order to accelerate a gered system?

0 Answers   TATA,

---

The maximum amount of axial load to be applied on a clutch plate is a) 100 KN b) 200 KN c) 300 KN d) 400 KN

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

The permanent reduction provided by the final drive in car is a) 4:1 b) 6:1 c) 8:1 d) 10:1

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What is the allowable -ve crankcase pressure (vacuum) in the gas engine of 1.5 mw?

0 Answers  

---

CRANK shaft to be fixed to the engine, ? (1) Perpendicular CAM shaft (2) Inclined to CAM shaft (3) Parallel to CAM shaft (4) None of the above

3 Answers  

---