Answer / manoj

If the difference between the Set Point and the Process Variable is directly proportional to the Controlled Output to the valve, then it is direct acting.

If both are inversely proportional then it is reverse acting valve.

Answer / nagesh

Output = SP-PV ------ Reerse acting
Output = PV-SP ----- Direct acting

How to connect PLC to DCS ?

2 Answers   Alkyl Amines,

---

how to install Differential pressure transmitter in gas line.i need transmitter down side.

7 Answers   Rockwell,

---

any questions on motor and energy conversions machines?

0 Answers   ABB,

---

Why boiler chimney area  oxyden sensor fixing? 

0 Answers   NTPC,

---

how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?

0 Answers   Texas,

---

---

pls tell me whethere flame proof HMI's are available or every HMI is manufactured by considering flame proof standard.

3 Answers  

---

How much should be the values and/or percentages of these given below factors for a good controller ? Steady state error Delay Rise Time Overshoot Peak Time Settling Time Damping Oscillations & vibrations thanks

1 Answers  

---

why we are using -24 vdc in plc?

1 Answers   CGL,

---

Why Pressure Transmitter is NOT installed before up-stream of an ORIFICE PLATE? in a flow measurement.

4 Answers   Mecon,

---

What is differnece between leveltroll and interface leveltrol?

2 Answers  

---

I want to know if flowrate increases in 16' pipe line what will happen to upstream pressure and why?

1 Answers  

---

How to zero trim the level transmitter by using foundation fieldbus communicator.

2 Answers   Emerson,

---