Answer / sarfaraz alam

The standard height of installed trans meter is
1.5 m from grade label to the centre of the
device but this standard may be changed
according to process requirement.

How to calibrate the control valve.

1 Answers  

---

To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.

0 Answers  

---

can i get model question papers of mahagenco exam?

11 Answers   MahaGenco, MSGEN,

---

Where are use of pressure,level,flow switches?and what is input and output

3 Answers  

---

send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com

0 Answers   HPCL,

---

HOW TO CALCULATE WAKE FREQUENCY FOR THERMOWELL???WITH OUT SOFTWARE..

1 Answers  

---

Shall we get the reading on level transmitter only by termination,without commissioning?

1 Answers  

---

when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?

0 Answers  

---

Difference between ultra sonic flow meter

0 Answers  

---

what is power factor?

1 Answers  

---

Why Flow measure in Square-root?

12 Answers  

---

few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters

0 Answers   Monnet,

---