what happen if any one phase of a slipring induction rotor winding is open?is it start or won't?
Answers were Sorted based on User's Feedback
Answer / meenakshi
though it is a simple answer, i don wanna mention it over
ere.plz ppl. go to the following link n check it out.
personally feel that its a must read content for any elec
engineer..
| Is This Answer Correct ? | 2 Yes | 2 No |
Answer / meenakshi
u vil find answer here...
http://www.ckit.co.za/secure/conveyor/troughed/electric_moto
rs/alstom/alstom---motorcontrol.htm
| Is This Answer Correct ? | 1 Yes | 4 No |
What happened when capacitor connect series in ac circuit?
How much difference can there be between HT & LT KWH unit consumption at the same load?
What is basic impulse insulation level? And how it is calculated for sub- station?
where HT & LT capacitor uses ?
Why is the starting current high in a DC motor?
In case of 3 phase motor why it is called single phasing by failure of one phare unless there is rest two phase are acting. ?
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
toughest decision you ever had to make
What is BKW of Motor. And what its significance
no EB power DG is not starting?
What are the weight of 800KV DA,DB and DC type tower ?
in electrical control panel. how can i choose the cable rating. (example - 11kw motor, 18-25A mpcb}
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)