what is milling and types of milling?what is drilling and
types of drilling? what is tapering and their types?
No Answer is Posted For this Question
Be the First to Post Answer
I got i20 for university of bridgeport,university of new heaven and eastern michigan university.Please tell me visa success rate for these universities.And I want to go to Connecticut.At that place two universities are avaliable one is new heaven and the another one is bridgeport.Which is the best? Please give reply as early as possible.
What is the use for firmer chisel?
what is critical speed?
32 Answers Power Grid, Reliance, Takreer,
why boiler is closed system ?
What is the plant heat rate and what is the turbine heat rate?
Maximum combustion temperature in gas turbines is of the order of 1100 to 10°c whereas same is around 00°c in i.c. Engine ? Why ?
what are normal TSI(turbine supervisory instrument)when at turbine at full load & when turbine on turning gear?
Is enthalpy represent the heat content of a substance? and is the substance is liquid or gas or solid? or all
What will cause if you run your engine in critical RPM continuously?
why does polytropic efficiency of a compressor decrease with increasing flow rate ?
Why head of a centrifugal pump is independent of density of fluid?.
Gearpump is running but discharge valve is closed so, what difficulty in pump?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)