Answer / koti

Bus bar = 2 nos of 200 X 12 mm Al
Cable = 5 R X 3.5 C x 630 Sq.mm Al

Answer / kshirod dash

cable size should be 6*600 sqmm aluminium armed cable 3.5 core
so that it will stand 2700 amp current

Answer / kennethbonn

Bus bar = 1/2 x 8mm @ 30deg.rise
Cable = 5090MCM

Why are calling leading power factor is a capacitive load?

1 Answers  

---

How cable from Kit-Kat to main switch, from starter to motor are designed?

0 Answers  

---

While connecting the flood light plug on to the 415 V distribution panel,there was spark and the cable got burnt. Three ignitors of the flood light also burnt of. The lamps are of 400 W (total 6 lamps) connected through 1.5 mm2 cable. The plug was immediately removed from the circuit. There was a 30 mA RCD connected and a 250 A MCCB; however both did not trip. What could be the possible reasons for the circuit devices not to trip?Can someone assist please. Additional info if needed can be provided.

2 Answers  

---

A 11000/415V distribution transformer is fed 415V upon it's LT side,Do I get 11000V upon it's Primary side ?

7 Answers  

---

why ac signals are sinosuidal

2 Answers  

---

One 200 V, 100 W bulb is connected in series with primary of a 200 V, 10 kVA transformer. If its secondary is kept open circuited, then the bulb would have (1) Full brightness (2) Poor brightness (3) A little less than full brightness (4) More than full brightness...explain

2 Answers  

---

how can we choose the size of road crossing pipe for power cables

2 Answers   DLF,

---

why inductancce of armature inductance of dc machines is neglected?

2 Answers   APPSC,

---

what is cro

3 Answers   HCL,

---

difference between microprocesser and microcontroler

1 Answers   HAL,

---

What are the protections to be used for Generator?

3 Answers  

---

i am working in automation feild my question is that how to find the KVA of transformer.

3 Answers  

---