Where are use of pressure,level,flow switches?and what is input and output

Where are use of pressure,level,flow switches?and what is input and
output

Question Posted / md.zafar eqbal

3 Answers
7587 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Where are use of pressure,level,flow switches?and what is input and output..

Answer / harihar dash

Pressure switch used on pressure line , Level switch used on Drum level and Flow switch used on Air flow line Input of these switch is 24VDC and output is potential free contact

Is This Answer Correct ?

6 Yes

1 No

Where are use of pressure,level,flow switches?and what is input and output..

Answer / greenborhan

1. Pressure switch used on pressure line/process line (pipe) to save the line/process from over pressure.
2. Level switch used on Drum/tank/vessel to see the level of the drum/tank/vessel.
3. Flow switch used the line through which fluid/liquid/air/gas is flowing, it confirms that if there is any flowing elements or not.

Input of all these switches are +24VDC and output of these are Digital Signal, these switches send a Digital Signal/Input to DCS.
My answer is right or wrong?? I am a little bit confuse...

greenborhan@gmail.com

Is This Answer Correct ?

3 Yes

0 No

Where are use of pressure,level,flow switches?and what is input and output..

Answer / farhan baig

Pressure switch used on pressure line , Level switch used on Drum level and Flow switch used on Air flow line Input of these switch is nothing and output is potential free contact

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

re i got gre score of 950,and toefl of 69 is this score sufficient actually my husband is presently in US i need to go please help me

1 Answers

LADDER LOGIC Can any body state Logic on following condition Instructions to use 1-XIC 2-XIO 3-Output ONLY Program Push 1st button On - 1st lamp should On Then Push 1st button Off - 1st Lamp Should remain on Push 2nd button On - 1st lamp should Off and 2nd lamp should On Then Push 2nd button Off - 2nd Lamp Should remain on.

4 Answers

how can i calibrate E & h make conductivity transmiter . unit : mocro siemens Range :0 to 100 micro siemens sensor : capacitive type

1 Answers

how to trim the pressure transmitter ?

2 Answers

I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?

0 Answers

i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?

0 Answers

What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?

0 Answers Jubilant,

what is the difference betwwen the 2wire level transmitter and 4wire level transmitter??and their applications also??

2 Answers

Intools training

1 Answers

what is the main supply source for pressure transmitter?

1 Answers

How to calibrate H2s Dectector

0 Answers KOC,

is any standard angle for thermowell mounting for horizontal and vertical pipe lines?

3 Answers

For more Instrumentation Interview Questions Click Here