Answer / simon

<1>11KV=11000V (Max V to b produced in india).Hence
11*1=11kv
11*2=22kv
11*3=33kv.
<2> The cheapest mode to improve P.f is using bank of cap (series or para).
<3>For that try to understand wattful & wattless components.

During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?

0 Answers  

---

Why reverse power relay is used?

12 Answers  

---

I want Primary side delta and Sec side Star connection transformer . but i have received Star - Star transformer ,shall i use the same transformer by giving the only 3 ph on Primary side without Neutral connection on the Starpoint.

5 Answers  

---

7. Why AC motors, AC bulbs etc... are donot operated by DC signals? and Why DC motors, DC bulbs etc... are donot operated by AC signals?

2 Answers   Bhel,

---

If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these

1 Answers  

---

How to select AC3 duty contactor for DOL & Star-Delta starters

1 Answers  

---

advantage of using 110v than 230v

1 Answers   NTPC,

---

What is formula of capacitor for 1-phase power connection.how to improve PF. Suppose I want to connect capacitor in refrigerator to reduce power consumptions.

0 Answers  

---

draw single line diagram of UPS

1 Answers   Adani Ports, Equate, IBM, SAP Labs, Socomec, TATA,

---

What will be cross section area of copper conductor for carry 2000 amps & 2500 amps....sq.mm.?/

3 Answers  

---

Initially motor starts with star connection ,after few timing changes to delta connection, why the motor should run continously in star connection,it gives high torque & low current?

3 Answers  

---

why one pin of plug pin is longer than other two? In some mobile chargers one pin is made not conducting .Why?

4 Answers  

---