Answer / brijesh

you can do the series connection, but check the load of the
isolator.

procedure to commission a drum level transmitter

1 Answers  

---

centrifugal compressor interlock? Tell me the parameter at which compressor will trip

0 Answers   Cairn,

---

why used three wire in RTD.

8 Answers   BARC,

---

What are the most frequent problem faces with Vortex flow meter?

1 Answers  

---

If the vibration probe near to the shaft,then output voltage will be decreased r increased?How?

1 Answers   Amtek, Hamsco, IJT,

---

I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?

0 Answers  

---

How to work temperature gauge?

0 Answers   KJS,

---

Can anyone provide me the details of GAIL test paper?What is the format and what type of questions will be there? my id-princegnb@gmail.com

1 Answers   GAIL,

---

why magnetic flow meter is not used in thermel power plant operation

2 Answers   JK Paper,

---

In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.

0 Answers   Essar,

---

Explain the thermocouple and RTD?

1 Answers  

---

CAN YOU USE MOVING COIL METER FOR MEASURING A.C?

2 Answers   DVC,

---