Answer / jsv sunil

Instantaneous Over Current Means when The Over Current Detected it will be tripped i.e.,at t=0sec but not in IDMT

IDMT means Inverse Difinte Min. Time,

Here, higher the current value lower the tripping time
Lower the current value higher the tripping time

Block diagram of Power line communication?

0 Answers   CIL, VIP,

---

A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.

0 Answers  

---

Why is negative feedback invariably preferred in closed loop system?

0 Answers  

---

What's the difference between non break power supply and non break non short break power supply

0 Answers  

---

what is L.T?specify the range?

7 Answers  

---

for selection of transformer we will considering 5 to 6 times of starting current of higher rating motor connected to secondary side. according to process wise we will start the motors gradually suppose if we will start 15 to 20 motors at a time wat will happen?

1 Answers  

---

Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm

0 Answers  

---

Why are we not getting shock while touching a metal which is being welded?

1 Answers  

---

how can you calculate the value of external resistance inserted in a slipring industion motor? (eg. 110 kw / 990 rpm/50Hz/stator v-415/stator Amp-195/Rotor V-440/Rotor amps- 151.)

6 Answers   Bosch, NMDC,

---

If we have a 2000kva load,How much kvar capacitors we go to add to improve the power factor at 0.9?pls give the calculation and fully theory?

2 Answers   ABB, Unitech,

---

what is a reactive power? what is the relation with power factor?

0 Answers  

---

What is earth fault?

3 Answers  

---