hello i'am samad.Any one Can help me! How to calibrate Vaccum Transmitte

hello i'am samad.Any one Can help me! How to calibrate Vaccum
Transmitter DP Type range 0 - 50 mbar abs by hand pump
calibrator.

Question Posted / samad

4 Answers
5804 Views
Bharathi Cement, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

hello i'am samad.Any one Can help me! How to calibrate Vaccum Transmitter DP Type range 0 -..

Answer / moin

Druck is supplying a pressure calibration with a range of -1 to +1 bar.with this you can calibrate.....

Is This Answer Correct ?

2 Yes

3 No

hello i'am samad.Any one Can help me! How to calibrate Vaccum Transmitter DP Type range 0 -..

Answer / m ramzan

yes you can abbly 0-50 mbar at low pressure side of
transmitter by any pressure sourse

Is This Answer Correct ?

1 Yes

2 No

hello i'am samad.Any one Can help me! How to calibrate Vaccum Transmitter DP Type range 0 -..

Answer / pankaj rathi

For calibration You can apply 0 to + 50 mbar. Pressure at H. P. Side.

Is This Answer Correct ?

0 Yes

1 No

hello i'am samad.Any one Can help me! How to calibrate Vaccum Transmitter DP Type range 0 -..

Answer / umair

For Calibration of Tx,You can apply pressure of 0 to 50mbar at LP side of transmitter with pressure pump.or
0-50mbar vacuum at HP side.

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Instrumentation Interview Questions

How to measure Flow of air line,what is the procedure of creating DP in line to measure Flow!

3 Answers

cheapest instru-- PMMC, EDM, rectifier, thermocouple.

3 Answers ONGC,

how to work MIL contol valve posistioner ?

0 Answers ABB,

How can i solve the problem of ROSEMOUNT 5300 guided wave level transmitter of full range? For more clearfication , another guided wave level transmitter VEGA brand have the same problem and i solved it by drain the champer from water and make "false signal suppretion" from transmitter push buttons it's configuration to tell the transmitter to avoid any built-up signal ,,, so my question how can i avoid the problem that rosemount read full range while the champer empty or any other ????

1 Answers

please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com

0 Answers

is manifold required for an integral orifice meter?

2 Answers

what is the advantage of submersible level transmitter compare to ultrasonic level transmitter?

0 Answers

What is meant by Fail Safe Condition in PLC?

4 Answers

GIVE BRIEF DESCRIPTION ABOUT "DCS"

2 Answers

Hello friends i need check lists of different instruments during the Erection and commissioning in thermal power plant.Please help me.My Mail id is naba02222@gmail.com/naba02222@rediffmail.com Thanks Nabakishore Biswal

1 Answers

how to check earthing,what is minum ohms for proper earthing

0 Answers

I have a steam flow DP transmitter that has output swinging. Steam valve is in manual.I have good steam pressure. The impulse lines have steam tracing on them. The steam tracing has a hole in it that is blowing raw steam on the high side impulse line only. Could this be causing the swinging?

1 Answers Honeywell,

For more Instrumentation Interview Questions Click Here