Interested to Buy Any Domain ? << Click Here >> for more details...
what effect on electrical equipment if PF is gone over 0.996
in leading when provider say that its keep in minimum
0.996lagging
- 3 Answers
- 7407 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / varaprasad inavilli
Electrical charges will be more
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is Different between Bilinear and Unilenier?
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
How much costly in percentage wise is sandwich busduct costly than air insulated busduct of any rating?
how can i apilly for electrical c licencese.sir,i completed B.Tech in electrical & electronics engineering in 201onot working any company
What is the previous name of Cox's Bazar
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
Do closed loop systems require manual input?
how to calculate mf when meter and cTPT detail are given
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
sir, 3phase induction motor takes different pf and different KW in three phase while running,explain reason
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
When we need up only in o/p 440v, so why we use directly in 11kva in input?
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
