In EHV transmission line a neutral grounding reactor is
often placed at neutral point of shunt reactors. What is
the recommended protection for this neutral grounding
reactor? Should I use a fast closing switch to bypass
neutral grounding reactor when this protection operates?
No Answer is Posted For this Question
Be the First to Post Answer
WHY IS wet surface used for grounding???
Why the Potential transformer Primary in connected to Earth?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
why characteristics of overcurrent relay is time-->psm instead of time-->current?
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
How to select a D.G set for calculated load of 110kW..?
7 Answers Shakthi Power Systems,
Is it possible to make 0.75KW motor earthing from MCC panel by using the 1.5 SQMM, 4 core cable, means 3 core for 3 Phases & 1 core for Earth terminal?
why lightning arrestor are made in two stack of insulator but why not cvt
Why usually in all electrical equipment taking more current in Y pahse like pumps,compressor,or any other applications
How to connect frequency meter in metering circuit?(single phase and three phase frequency meter)
what is the use of ballast in tube
what is the difference b/w earthing and grounding??