if we mount flow tube in arrow direction then flow comes in
negative & if we mount it another direction then flow comes
positive,So what will be the problem
Answers were Sorted based on User's Feedback
Answer / jaydipkhatri
mass flow direction ok .but its configrat on reverse direction.
| Is This Answer Correct ? | 4 Yes | 0 No |
when the force applied on load cell the ohms will be varriying .and how its convert ohms to mv generate and have any formulae?
1 Answers UETCL Uganda Electricity Transmission Company Limited,
what is puling in n pulling out in flame scanner system?
How RAL(Rotary air lock)works in cement industry?
Why Pressure Transmitter is NOT installed before up-stream of an ORIFICE PLATE? in a flow measurement.
how can i calibrate E & h make conductivity transmiter . unit : mocro siemens Range :0 to 100 micro siemens sensor : capacitive type
Name some of the common protocol use in automation.
What is the procedure of calibration of Load cell?
What is the Difference between PE,IE and ISE
What is close loop ?
1 Answers College School Exams Tests, GMR,
what is the reason while warning lamp is on while the engine is cranking?
hey any one got the papers of SAIL and HPCL plz do help me by posting them to my mail ID's naren07_87@yaho.co.in, surenarendra@gmail.com
What is the difference between relative vibration
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)