how to decide cable rating? send me cable size,ampere rating
data
Answers were Sorted based on User's Feedback
Answer / engr. kashif
U can download cables and tables from website of any
cable manufacture for ur required data.
Is This Answer Correct ? | 0 Yes | 1 No |
Answer / er. naresh singla, from bathin
Please tell where did you use the cable. i.e. for control
and power purpose.
For Power cable :-
LT purpose :- 1 sqmm cu cable :- it will take 4 amp current
a/c to formula you can calculate the cable size.
LT purpose :- 1 sqmm al cable :- it will take 1.5 amp
current a/c to formula you can calculate the cable size.
HT pupose :- we can go a/c the LT purpose cables but there
is voltage drop plays very crucial role, first calculate
the current value then calculate the voltage drop after
doing these exercises you can select the cables.
Is This Answer Correct ? | 0 Yes | 1 No |
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
what is general test conduted by transformer
When distance between two pulleys is not fixed, the tension of belt is adjusted by a) driver shaft b) driven shaft c) adjustment screw d) belt
why would amp draw on neutral wire be as much as amp draw on the hot leg.
what is the maximum load on for 10 kva & 25 kva transformer
why voltage is low at reciving end in summer??
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
what is the working principle of Brushed alternator ? without exictation how we can give dc supply to rotor ?
Who are the manufacturer for Nitrogen based Fire Protectio/explosion prevention for Oil Filled Transformers? India and international both?
is there any role of power factor with frequency variation? and how we can manage the frequency variation?
It is observed that AVR of an Alternator is more likely to fail if the Generator and Mains Neutral are directly connected to each other. Why should this be so?
how to determine ct ratio in ht vcb?