Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ch v kishore kumar
The line tester is withstand up to 500 volt's.
so that is the main reason to write 500 volt's.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
how to find impedance , mutual indatnce in transmission lines
What is safety of Ht panel
How to address the servo drive for motor
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
what is the interrelation between voltage current torgue speed and magnetic flux in case of different types of electric motors
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
why are the maintaine power factor and how can this control and this is how work.
when ID fan will immediately stop through VFD what exactly cause and problem the ID fan
how to test and calculat the head and discharge in borewell compressor
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
Graphs of measuring power and speed on dc motor
Why compensation is necessary in feedback control system?
What is the drawback of class b amplifier?
HOW TO CALCULATE THE VT SIZING?
Can we use a absolute encoder to show rpm of a motor ? what about the condition when power is off ? what is difference if a incremental one is used ?abanirout@gmail.com
