Answer / vikas thokale

as LT panels are designed for 240 or 440 volts and HT panels
are for 11kv and more.And to deliver same power this high
voltage requires less current.

as
power = voltage x current

that is why HT panel cable size is less than LT panel cable

Answer / sheikh

Because High Voltage (ht) drawn low current therefore there is
not neccessary to use large size of cable. Lt side drawn more
current so there is neccessary to choose large size of cables.

Answer / ch v kishore kumar

because HT Voltage having a high voltage & low current and we are providing high insulation in bitwen of phases.LT voltage is having low current & high current. we are providing low insulation in bitwen of phases.current depending of cross section of cable.More cross section more electrons flow & less cross section less electrons flow.

Answer / hemalatha

because HT Voltage having a high voltage & low current and
we are providing high insulation in bitwen of phases.LT
voltage is having low voltage & high current. we are
providing low insulation in bitwen of phases.current
depending of cross section of cable.More cross section more
electrons flow & less cross section less electrons flow.

what reactive how to maintain

0 Answers  

---

what is the difference between LLL and LLLG fault ?

1 Answers  

---

why we usually call 415 volts instead of 440 volts

3 Answers   S Tech,

---

What is the difference between synchronous motor & asynchronous motor

2 Answers  

---

What is the difference between Relay and Contactor

35 Answers   Siemens,

---

if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.

0 Answers  

---

what is laser diodes?

0 Answers  

---

how does an energy meter works?

4 Answers  

---

Why phase sequence ryb called colours.

1 Answers   MS Life, NTPC,

---

Just a silly question but just to make my curious mind bac to normal - Why was not 67 and 67N relays built into a single relay as i have noticed that the R,Y,B CT wiring end up into the 67 relay while the common of the R,Y,B CT wiring end up into the 67N relay. Then it was better if a single relay was manufactured just like the distance relay (21). Another question i would like to ask is - how do we know where the 67 and 67 N relay has to be placed.why is it not placed at the transformer bay? In the substaion that i am working -i have noticed that it is placed between a breaker and a common double bus bar and this line bay is connected to another substation at a remote place which is furthur connected to a load. B U S______CT for 67 & 67N ______Breaker _____ remot s/s. B A R

1 Answers  

---

What is the frequency of dc current????

4 Answers   SCS,

---

What are the precautions to be taken before working on a cable?

1 Answers   Alfanar,

---