Can anybody just suggest about the scope of Electrical
design with ETAP software?Just guide me?
No Answer is Posted For this Question
Be the First to Post Answer
difference between synchronous reluctance motor and switched reluctance motor
How to calculate the input cable rating for 10kva ups (3phase input and single phase output and also 3phase output, battery rating 65Ah)provide the formula also.thnx
what is meant by 2 within a star in a voltmeter dial?
How RTCC works with OLTC
There is any especial requirement for motor to drive through with VFD?
Frequency of rotor emf in induction motor is around A same as stator frequency B 50% C 5 % or below D 30%
what is interpose? where it is used and why it is used?
three owners X, Y, z owned some tractors with them, on the first month x gave away the same amount of tractors to y and z ( as much as they possed), similarly in the 2nd month y gave of to x and z similarly by third month z gave to x and y. after this all X, Y, Z had 24 tractors each.
How can we find out LT UG cable fault (size,from-4*25mm sqr to 4*300mm sqr)? How mani types UG cable faults?
Essential condition for parallel operation of two single phase transformer is that they should have same A polarity B kVA rating C voltage ratio D % impedance
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
what will happened if generator runs with slow speed?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)