in shunt clippers why a resistor is used in sereis with the
input
No Answer is Posted For this Question
Be the First to Post Answer
what happen if transformer neutral not earth
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
What is the maximum allowed kwa through 2.5mm cable. Electric company installed 2 electric meter at my premises . Two jumper wires of 2.5 mm are used to connect . 2 single phase meters with allowable load 6 and 3 kwa. These jumper wires are taken from a 3 phase electric meter. Meters are in open Sun. What max load these wires can take.
what are all the components required to assemble solar panel other than pv cell?
The inexpensive way to improving energy efficiency of a motor which operates consistently at below 40% of rated capacity is by _____.
Please explain me about Relay curves and their sources to read ?
How to check the cable fault / hv test of transformer cable.
How we calculate the current carrying capacity of H.T. cabel?
what is second harmonic, how is effect transformer ?.
What are the main factors to be considered(In terms of energy conservation) while selecting a new air compressor?
What will be the total current for 300kva UPS if it runs on 40 to 45 percent load. Is there any formula for to calculate the exact load.
technical questions asked by visa steel interview plg get me!
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)