Answer / kj

Current will flow through the water. If the wires ar close
enough it will cause an overload. If they are far enough
apart they will heat the water and can make the water boil
between the wires.

This method has been used to load test DG's. 3 pointed
metal plates are fixed onto a triangle of wood and a phase
connected to each. When the plates are lowered into the
water current will flow through the water. The further the
plates are lowered the greater the current.

Note that this is very dangerous if great care is not taken
and all people are kept away from the water.

what is unit of inductance

12 Answers   Bhel, Bosch, OSML, Vijai Electricals, Voltage,

---

what is (+) and (-) in generator field detector stand for?

0 Answers  

---

what is voltage gradient?

8 Answers   Bhel,

---

what is the diff between VCB & ABCB breaker in substaions? explain the operating priciples of VCB & ABCB

1 Answers  

---

why are we using resistor in NGR ?

1 Answers  

---

i want to know is it possible to generate usefull power by coupling generator with motor & supply gives to motor by battery source then generator generates power. remove the battery source given to the motor & feed the supply from some of the generated power supply to the motor & motor runs continously. generator generate power contnously.is it possible ?

5 Answers   UltraTech,

---

What is the simplest formula to calculate the rotor diameter of a synchronous generator?

0 Answers   PEI,

---

why you don not show protection and type of isolation in key single line diagram?

0 Answers  

---

How can a transformer test by megger?

1 Answers   Bosch,

---

what is transformer?

4 Answers   Mphasis,

---

1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to reconfirm its base capacity.

0 Answers  

---

From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?

0 Answers   Schneider,

---