Answer / mohammed kamil

A feedback system, in general engineering terms, is a system
whose output if fed back to the input, and depending on the
output, your input is adjusted so as to reach a steady-state.

What is the relationship between Sensor

6 Answers  

---

In my plant I want to mount a steam flow transmitter .Flow nozzel is already mounted in steam line .So how can i know the range to put in flow transmitter?

1 Answers  

---

what is difference between 3 wire and 4 wire RTD sensor?

12 Answers   HTA Instrumentation,

---

Tell me about the synchronization panel.

1 Answers  

---

I want condensate pots vent position erection of flow transmitter ?

1 Answers  

---

Please explain the difference between instrument range and calibration range in terms of pressure transmitter? line design pressure: 93 bar operating pressure : 82 bar press Transmitter Range? calibration range ?

3 Answers   L&T,

---

can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know

0 Answers  

---

Explain about signal isolator

1 Answers   TCS,

---

how to trim the pressure transmitter ?

2 Answers  

---

How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?

0 Answers  

---

A temperature sensor (RTD) connected via a temperature transmitter is adjusted to give an output of 4ma at 60 deg and 20 ma at 600 deg. This output (4-20ma) from the transmitter is connected to an IGBT-inverter to control a high speed (-12,000 to +12,000 RPM) DC motor. And in the inverter it is programmed as, for 4ma the motor speed will be -3,000 RPM and for 20ma the motor speed will be +10,000 RPM. The question is : If the motor speed is +5,500 (RPM), what will be the temperature? (-sign indicates that the motion is in reverse direction).

9 Answers  

---

what is the significance of hook up

3 Answers  

---