why use 50% lel methane gas concentration for gas detector calibration instead

why use 50% lel methane gas concentration for gas detector
calibration instead of 60% lel gas concentration whereas the
hi alarm set at 60% lel.

Question Posted / ex_pang5

No Answer is Posted For this Question
Be the First to Post Answer

More Instrumentation Interview Questions

principle of rtd

In Boiler Drum Level- Level control valve how can it tuning (PID)?

what is output of FOUNDATION FIELD BUS transmitter

What is feed factor and its Importance in cement industry? How we can solve feed factor?.

How to control flow variations in magnetic flow maters..... When i will provide proper earthing?

what is dry leg and wet leg in transmeter calibration?

IF PLC POWER FAILURE THEN WHAT HAPPEN?

What is the Flow rate ?

what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?

What is the live zero and dead zero

how to install the Ph and Conductivity analyser? is there are any procedures which has to be maintained.

what is zenier barier and what means zone 1,zone 2,and zone 3

For more Instrumentation Interview Questions Click Here