Answer / danishdeshmuk

why the Parameters : Base Voltage & Maximum Voltage can't be
equal in value in a VFD (Variable Frequency Drive) ?

How much the base voltage would be lower than the maximum
voltage ? If 400 V is the 3 phase output of a VFD ... then
what should be the base voltage ?

thanks a lot

what is meant by class 1 E in electrical power supply?

0 Answers  

---

What are the advantages of autotransformer?

0 Answers  

---

I want to ask a question which i faced during testing of Capacitive Voltage Transformer in AIS. We have measured the C1 , C2 individually , but when we start to measure the total C1+C2 , the testing equipment shuts down and says low loading. Kindly is it possible to find the total capacitance by using measuring device. kindly briefly explain the procedure.

0 Answers   AIS,

---

What is the basic difference between the electrical engineering and electronic engineering?

4 Answers  

---

what kn of disc is used in 33kv,132kv,220kv,400kv,800kv transmission line

0 Answers   Jindal, Power Grid,

---

Which material is used for the core of a transformer and why?

0 Answers  

---

Electricty is generated at around 16kV, then step up to 220kV for transmission then steped down to power transformers then DTs and then through the LT n/w it reaches the consumer end. At the consumer end 230V supply is required. So, why is electricity not generated directly at 230V and transmitted?

4 Answers  

---

What is the difference between air & vaccum circuit breakers?

2 Answers   IOCL,

---

What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?

0 Answers  

---

HOW TO MEASSURED THE AMPS RATING FOR SUITABLE CABLE SIZE?

4 Answers  

---

'documenˁ

0 Answers  

---

how to make a solar panel? why solar panel cell connected to serious?

1 Answers  

---