How to distinguish between the armature wires with the field wires of a Dc motor ?
Answers were Sorted based on User's Feedback
Answer / shahbaz shaikh
in the above answer he told that the field winding is in
rotor but it is wrong because the field winding is wound on
the stator incase of d.c motor and it is stationary and the
armature winding or counductor placed in the armature slots
and the external supllay is given to the field winding and
it will produce the rotating magneting field.
| Is This Answer Correct ? | 5 Yes | 3 No |
Answer / mrinal kumar
Field wire/ winding- it is used as a primary source of flux when current is passed through it. It is also called as exciting current. The current flowing through it is always dc.
Armature wire/ winding-it is an arrangement of conductors in which emf is induced. Practically armature winding is placed on the stator while field winding is placed on the rotor
| Is This Answer Correct ? | 4 Yes | 3 No |
Answer / danishdeshmuk
Can we distinguish these two by measuring the resistances ?
Whose resistance should be higher & whose should be lower ?
| Is This Answer Correct ? | 2 Yes | 1 No |
Answer / mrinal kumar
friend field winding is wound on the rotor only and yes dc supply is given to the field winding which will lead to the rotating magnetic field
| Is This Answer Correct ? | 2 Yes | 4 No |
Answer / mrinal kumar
see, starting current is very high in dc motor & is nearly equal to the supply voltage. and since supply is given to the field winding so you can say starting current is high in field winding and thus its reistance value is very small or negligible. Armature current flowing through armature winding is connected to the load so depending upon the load current its value fluctuates.
| Is This Answer Correct ? | 0 Yes | 3 No |
why the conservater tank alwes made upper side of transformer???
whatdo mean by chopper fed drives.used for ac drives.
is 3-phase induction motor need a starter ? why do it so
In UPS what does 600va reffer to?
how do the stepper motor works.
why servomotor motor? where i apply for best output?
What is a formula to decide the size of the cable of the star delta motor ( From Contactor to the motor 2 runs )
10. THE MOST COMMON TYPE OF THREE PHASE IN UNSYMMETRICAL FAULTS IS ........
what happens when a dc shunt motor fed with an alternating suppy ?
Why we generate power at multiple of 11 i.e 11kv,33kv etc.
9 Answers DTV Solutions, Havells, TCS,
What is the purpose of stand by earth fault protection for transformer ?
what's ripple content in rectifier? how it formed?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)