What is the meaning of the term "g force"?

3 Answers   Reliance, Saint Gobain, Thermax,

---

Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify

3 Answers  

---

To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.

0 Answers  

---

Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?

0 Answers   Process Control Technologies,

---

How to work & calculated output of the Derivative action in pid controller (Explain Derivative controller)

0 Answers  

---

HOW WE MEASURE A DRUM LEVEL BY DP TRANSMITTER ? WHAT IS ITS FORMULA ?

2 Answers   Thermax,

---

why cant we use mV instead of mA?

12 Answers   ABB, Power Grid, Qatar Gas, USW, Visa Steel,

---

What you mean by multi stage control vavles?

0 Answers  

---

HI friends.I am Surya a BTech in Electronics and Instrumentation Engineering.I am going to appear Relince Industries Ltd all India writen test very soon. so plz help me by sendind the probable questions about my subject.My mail ID is surya.barik@gmail.com.

0 Answers   Reliance,

---

What is zero elevation and zero suppression?

0 Answers   CCIE,

---

Yokogawa mass flow meter shows negative reading...what r the main causes for this problem?...

3 Answers   IOCL,

---

how do i calibrate mmwc pressure guage with out calibrator.if any? pls give me the ans.

1 Answers  

---