Which is the best between SCADA & PLCC & Why ?
Answers were Sorted based on User's Feedback
well first of all you should be clear dat wat is d full of
PLCC & SCADA.
PLCC stands for POWER LINE CARRIER COMMUNICATION whereas
SCADA stands for SUPERVISORY CONTROL AND DATA ACQUISITION.
Both PLCC and SCADA are used for the data acquisition using
RTU(Remote Terminal Unit). But you see SCADA provides and
additional function, it can control the load dispatch of the
system or say power system management hence required in
SLDC's(State Load Dispatch Center) whereas PLCC is used in
every grid substation, switching substation, generating
substation etc. only for communication purpose and data
acquisition. Installation of SCADA system is way costlier
than PLCC.Both of them serves different purposes.
| Is This Answer Correct ? | 13 Yes | 2 No |
Answer / m.subashree
PLCC is the programmable logic control which is used to
interlocking of different components.
SCADA means data acquisition system some times its not
perform a control operation...
| Is This Answer Correct ? | 3 Yes | 12 No |
What are the Steps for Testing of 20MVA (make:-CGL) Transformer? How many Test we have to do?
How over load relay works.
Why two nos. un-tensioned wires are placed inside the PSC poles used by powergrid in RGGVY works.
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
WHAT IS OLTC OF TRANSFORMER? WHERE IS ITS USED EITHER ON PRIMARY OR SECONDARY SIDE OF TRANSFORMER?
What is Class and accuracy in CTs? Types of Classes and important of Classes?
what is the Pickup/drop off ratio in BCPU relays
what is the burdon in case of relays?
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
where transformer is installed? a)generating station b)substation c)voltage regulating area
according to faraday's law whether the induced emf is average or rms value?
The efficiency figures for energy efficient motors (in comparison with standard efficiency motor) can be generally higher by____%.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)