Answer / rajeshsonic

capacitive transducer has

low snesitivity
output change wrt input is not significant with large value
of input signal

poor linearity i.e output is not proportional to input

here output is capacitance change ( converted to voltage )
and input may be distance / level / pressure measurement etc
]
we use opamps for this demerit

What is VSCF windelectrical system?

0 Answers  

---

1. alternator has full load regulation of 4% when pf of the load is 0.8 lag, 1500 rpm. full load regulation of 1400 rpm for 0.8lag will be ________ ?? 2. torque angle of a sync m/c operating from a constt voltage bus is usually defined as space angle between _______ . 3. method most effective in finding out no load losses in large DC shunt motoris ______ . 4. current carrying capacity of fuse material depends on ______ . 5. coil has res. 10 ohm, inductance 1H. what wil be current after 0.1sec after switching on to a 500V DC SUPPL ? ? 6. effect of phase lag compensation on servo systems ___________ . 7. rotor of a dc machine is usually supported upon ______ . 8. DC motor is preferred to AC motor in which application ?? 9. 3 nos of 10:1 Xmer are connected in Star-Delta to supply a load at 230V.the supply voltage must be ______ . 10. voltage source produces max current in which circuit. 11. cal. power, if current and voltage are out of phase by 90 degree. 12. suitable length of Xmission line of power at 66 KV. 13. Which of the theorm helps in simple computation when the load across a ckt is varying ?? 14. what is the adopted line length for power Xmission of power by cables ??

5 Answers   TATA,

---

for star delta connection,,why the contactor star not burn,when red,yellow and blue cable is looping.

2 Answers   Mahindra Water Utilities,

---

what is ring system ?

3 Answers   Bhel, Sabic,

---

What is EPBX????

3 Answers   Emerson,

---

Is there any particular formula for sizing the bus bar based on the current rating

1 Answers   Bunt Solar,

---

how to carried out tan delta test in 11 KV alternator ?

0 Answers  

---

The power dissipated by a resistor of 10ohm when a current of 2A passes through it is:(a) 0.4W(b) 20W(c) 40W(d) 200W

2 Answers  

---

power requirement of an l.e.d?

2 Answers  

---

why do we provide metallic enclosure to bus duct and then ground it?

1 Answers  

---

A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.

0 Answers   TCS,

---

Dear sir, I completed DECE In the year 1995.Now i am working in a private company from last 10 years as an Electrical supervisor.The company having a 1000 KVA transformer.Now i try to apply "C" Licence. I am eligible or not.If not eligible,pls give solution.

0 Answers   Balavigna,

---