Answer / ashish

The control of a turbine with a governor is essential, as turbines need to be run up slowly, to prevent damage while some applications (such as the generation of alternating current electricity) require precise speed control. Uncontrolled acceleration of the turbine rotor can lead to an overspeed trip, which causes the nozzle valves that control the flow of steam to the turbine to close. If this fails then the turbine may continue accelerating until it breaks apart, often spectacularly. Turbines are expensive to make, requiring precision manufacture and special quality materials.

Answer / k.sankar

Governor has two valves one is TTV-Trip and Throttle
valve,second one is governor control valve.
Speed governors may used to control the speed of the steam
turbine.It's such a way set to operate with in minimum and
maximum speeds.
After opening the throttle valve the turbine develops speed.
After a certain speed attains the governor takes the control
and opens the governor valve to increase speed.

Answer / amar

speed governor gives the power to the turbine when the steam label goes down to its natural condition .

it store the power when the steam label is high and gives at require period

If a 2 kg rubber is dropped in 8 kg water container(water will not come out from the container), what will be the total weight- incase when the rubber sinks in the water and when the rubber floats on the water?

2 Answers   Hero Honda,

---

what kind of carrier you would like to build yourself?

9 Answers   Kirloskar, Timken,

---

What is meant by effectiveness?

0 Answers  

---

How to calibrate Vacuum Gauges if you don't have any standard gauge available with you? please suggest procedures for calibration of Vacuum gauge like pirani gauge ,cold cathod gauge,thermocouple gauge without any standard gauge.

0 Answers  

---

In a Waste heat recovery boiler feed control valve is after the economiser where as in auxilary boiler feed control valve is given before the economiser.why?

2 Answers  

---

how does an EDM works?

2 Answers  

---

which cycle use in thermal power plant?

13 Answers  

---

What are the causes of damage to propellers?

0 Answers  

---

describe a type when u anticipated potential problems and development of preventive measure.

0 Answers  

---

Where pneumatic system is used?

0 Answers  

---

WHAT IS C.C IN AUTOMOBILE????

11 Answers   IBM, Pricol, TATA, Tata Motors,

---

Suppose water is there in a pot. It is being heated continuously untill formation of superheated steam. What is the temperature profile of water?. What is the temperature profile of the pot?.Imagine pot is heated from bottom.

1 Answers   Ashok Leyland, IGCAR, Videocon,

---