Answer / pandu

stain less steel is hard to desing as we required, and
economically cost is more. hard to mould in desired shape

Answer / ravikanth reddy

because the stainless steel and concrete having different coefficient of thermal expansion co efficient. due to different co-efficients the thermal stresses arises that leads to the failure of the member.

the steel using in present industry are having good bond with ribs and grooves on the bars and stainless steel having smooth surface so that stainless steel arises bonding problem.

Answer / vinod

because due to concrete is weak in tension

what is the out turn of one masson in plastering, masonary work in 8 hours, with limited healper? what is the out turn of corpender in form work? wood work? in 8 hour with limited healper? what is the out turn of bar bendarin 8 hour with limited healper for slabs, beams, coloumn?

2 Answers  

---

What is the use of array command?

0 Answers  

---

in BUILT UP AREA BASIS WHAT IS RATIO OF CONCRTE & STEEL RATIO MAY BE CONCIDER IN PER SQFT QTY

2 Answers   L&T,

---

Define line type?

0 Answers  

---

what is m30 in concrete tiles

0 Answers   Interex, Raj Construction, Spago,

---

---

What is Curtailing of R/F

0 Answers  

---

How to calculate cut bar length of steel reinforcement?

7 Answers   BCON, Jindal, MAT,

---

How high should the water tank be to provide a 60 psi at base of this water tower?

0 Answers  

---

How many kilograms of sand required in cufic feet for one cubic meter of M25 grade concrete

4 Answers   JSW,

---

How can effect the Floor tiles if water absorption value is higher than 0.5%?

1 Answers  

---

how much percent are used 20mm,10mm?

0 Answers   SCC,

---

if we know load bearing capacity of the soil and building load falling in each footing, then how to choose the type of foundation??? and if it is shallow foundation then which type of shallow foundation should be choosen i.e either strip or isolated or raft or combined or cantilever footing???????

0 Answers  

---