Answer / ruban

Before fitting rings, please insert rings into liner and check the clearance of liner gap by feeler gauge.

Answer / amol

1) Please insure tappet and valve settings are correct.
2) Please insure engine timing is correct.

Answer / brundaban chandra das

we have to check the id of liner through bore gauge if any worn out due to deviation creat. secondly inserting ring in to liner the ring gape and to check both the compression gape should be opposite to each other.And to check the first ring should in the upper position and tapper to out side and second ring accordingly.

Interlocking mechanism is provided in the gear box cover a) To prevent engagement of two gears simultaneously b) To prevent engagement of reverse gear c) To facilitate the gear selection d) To avoid the necessity of having neutral gear

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

haw meany type engine

3 Answers  

---

What is bhp? How can you measure bhp?

0 Answers  

---

Why oil with petrol can be used in two stroke engines but not in four stroke engines (two wheelers)?

0 Answers  

---

IN AC mechanical fuelpump what stands for AC

6 Answers   Cummins,

---

What is the function of commutator in starting system?

0 Answers  

---

If a diesel engine is running at 2500 RPM, How much would be RPM of turbocharger?

0 Answers  

---

What is the significance of bs 3 or 4 engines?

0 Answers  

---

automobile

2 Answers  

---

High speed gear is obtained in the case of sliding mesh gear box when a) Motion is transferred through the clutch gear to lay shaft gear b) Main shaft is coupled to the clutch shaft c) Smallest gear on the lay shaft is engaged d) Largest gear on the lay shaft is engaged

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What do you understand by ductile-brittle transition temperature?

0 Answers   Ashok Leyland,

---

Tell me the difference between torque and power?

0 Answers   GM General Motors,

---