Interested to Buy Any Domain ? << Click Here >> for more details...
if the piston ring & liners changed after that if problem
arising again of back compressor?
- 3 Answers
- 6980 Views
- MAHINDRA, TATA, I also Faced
- E-Mail Answers
Answer Posted / ruban
Before fitting rings, please insert rings into liner and check the clearance of liner gap by feeler gauge.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
If the given tractive effort curve and the total resistance curve does not intersect, then a) The vehicle will accelerate b) The vehicle will decelerate c) The vehicle will not be able to go at this gradient for the given gear d) None of the above
Where is fan located in car?
High speed gear is obtained in the case of sliding mesh gear box when a) Motion is transferred through the clutch gear to lay shaft gear b) Main shaft is coupled to the clutch shaft c) Smallest gear on the lay shaft is engaged d) Largest gear on the lay shaft is engaged
Why does a compression engine use high –octane fuel?
What do you understand by Newtonian Fluid? Where is it used?
Why injector pressure is used in heavy vehicles?
What is an injector pressure in heavy vehicle?
What are internal combustion engines?
What is the allowable -ve crankcase pressure (vacuum) in the gas engine of 1.5 mw?
What is Kirchhoff's Law ?
Explain various types of breaks.
Mention the importance of sae to the automobile domain.
The function of Differential is a) To prevent wheel skidding b) To reduce the speed of the inner wheels during turning c) To keep the speed of all the wheels same when going straight ahead d) all of the above
The maximum amount of axial load to be applied on a clutch plate is a) 100 KN b) 200 KN c) 300 KN d) 400 KN
What is an injector pressure in heavy vehicles? Why it is used?
