Dear all, Will some one help me in this issue please? We are entering th

Dear all,

Will some one help me in this issue please?

We are entering the Zero Stock Component in Maintenance
Order, and we make a Check when the order creator is going
to release system will appear Error, until he will not
delete that zero stock components from the Maintenance
order. but right now what the order creator is not releasing
the order but he is going to save order, when's he save the
order without release system will generate Reservation in
the back ground, which should not happen for Zero Stock
Components ? I need the way which we are doing in MB21,
Reservation creation by thru Cost Center / WBS Element. At
present if you run MB21 and you are going to issue the
material system will not allow to generate the reservation
if there are zero stock components in the list. please guide
me for this issue ?

Note : Simple what I need is I don't want to create any
reservation thru maintenance order for the Zero Stock
Components.

Regards,
Abdul Mujeeb

Question Posted / princemujeeb2012

0 Answers
1383 Views
Saudi Ceramics, I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Mechanical Engineering Interview Questions

How much pressure on air reservoir?

0 Answers RRB,

What parameters to be reported when we send lubricating oil for shore analysis?

0 Answers RRB,

what the role and resposibility of mech engg in power plant project.

2 Answers ACC, Torrent Power,

motor pump

1 Answers

what is the equvalent indian material code for EN10025/2- S75JR

0 Answers Apollo,

Respected Sir, Please send me the technical question paper of ONGC of mechanical branch.I m in urgent need of it.

7 Answers NTPC, ONGC,

What safety device will activate to stop the compressor in the refrigeration system

0 Answers RRB,

Explain mechanical refrigeration.

0 Answers

• Would you be willing to relocate if required?

1 Answers Petro Star Mount,

i am going to appear for section engineer which is conducting by RRB chennai. i want some model question papers my emai ID is chakku_mech10@yahoo.co.in

0 Answers

Why coupling should be located very near to the bearing? Why lap joint not recommended for tensile force?

0 Answers

What is the measuring unit of tensile strength in Gray cast iron ?

2 Answers Mico,

For more Mechanical Engineering Interview Questions Click Here