in three 3.5 core aluminium ug cable. one cable is used for one phase by shrti

in three 3.5 core aluminium ug cable. one cable is used for
one phase by shrting R,Y and B wires and other 2 cables
used for Y and b phases. balace 3 neutral wires are made
common and connected to load. suddenly neutral current was
more than line current what is the reason behind this?

Question Posted / lokesh

1 Answers
2612 Views
DLF, I also Faced
E-Mail Answers

in three 3.5 core aluminium ug cable. one cable is used for one phase by shrting R,Y and B wires a..

Answer / k.prakashchandra

The neutral current becomes more than the line current when the voltages applied to balanced 3 phase load , are not equal

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

explain why the secondary terminal of current transformer should not be lift open circuited.

2 Answers

How to connect a ELCB with contactor and relay ?

0 Answers

Star & delta kis principale pa hai.

3 Answers ME,

how to carried out tan delta test in 11 KV alternator ?

0 Answers

can we share mvar in parrelell connected alternators

2 Answers

why we can turn on the phase-A scr in 3 phase converter at 30 degrees

1 Answers JSW,

transformer 3 ph, 225 kva pri 480v, sec 208v. primary neutral connected to system, is secondary neutral to be grounded and how

1 Answers

What is fault.?

2 Answers AngloGold Ashanti, MNC,

In motors how many types of cooling systems were used?

0 Answers NTPC,

is it possible to flow currnet between earth and nutral wire in a circuit???

2 Answers

What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!

0 Answers Bhel,

When we synchronize the Generator BKR with TIE BKR then Gen BKR is hold but TIE BKR is Tripped on Non directional over current but when TIE BKR is Syn. with Gen. BKR then no fault occur so what is the problem

1 Answers ABB,

For more Electrical Engineering Interview Questions Click Here