Three set (each phase contain 2 cable of 400 mmsq CU XLPE AWA) of single core cables are connected to 11 KV motor of 14 MW & the switch gear supplay is taken from 11kv feeder & this supplay taken from 275 KV substation. Problem is one pair cable(L3- 2 cable ) getting very hot & gland melted and damaged in switch gear side. the other two cable haven't any more hot(ambient temp only & L3 haveing 95- 100 Degree C. The same problem happened in 275 KV substation switch gear side also where the supply taken for 11 kv switch gear. But here L2 phese cable had problem. Why it is happening like this?. The cable having temperature different at different location from gland side inthe case of 11KV feeder of 275 kv substation. why ?

2 Answers  

---

What is APFC Panel????

5 Answers   Emerson,

---

What is the role of feedback in a closed loop control system?

0 Answers   GE,

---

Load 380kva eb 415v,load amps 350.Same load dg 415v,load amps 420 what reason ?

1 Answers   AVT Natural Products,

---

How time response of the system is divided?

0 Answers  

---

Why oil preferred over the air as a cooling medium for high rated transformer?

1 Answers  

---

How to find ampere on ht side for selection of cable size ???

0 Answers  

---

block diagram of 2 ups system connected in parallel mode?

0 Answers  

---

how to calculate the starting current of a motor? gopal

3 Answers   JIPT,

---

Explain the operation carried out in thermal power stations?

0 Answers  

---

what's the simultenous maximum demand (SMD)..what the diffrent MD and SMD?

0 Answers   HAL,

---

How to size a transformer which will supply power to 550kW,690V motor starting with VFD?

1 Answers  

---