Why a Permanent Magnet Generator has higher frequency as
compared to frequency of main alternator?
No Answer is Posted For this Question
Be the First to Post Answer
why we get 2 differnet values for power factor in 2 watt meter method in 3 phase
A 25MVA 3300/400V T/F is termed as per winding is …… a) primary 3300V & Secondary 400V b) primary 3300V & low voltage winding 400V c) High voltage winding 3300V & Secondary 400V d) High voltage winding 3300V & low voltage winding 400V
4 Answers Engineers India Limited,
If Polarization index of motor 8.75 at 500volts of medium voltage 4.16 KV motor what this mean winding good or bad pl answer if any reffrence book give me the link
Why we use auxillary relay ? what is function of differential relay, directional o/c relay?
0 Answers Century Rayon, Mechanical,
how many earthing should give for transformer body and nuetral
what is the use of conservator in a transformer?
6 Answers L&T, TATA, Tata Motors,
what is the difference between series and shunt compensation using facts in a transmission line
8 Answers College School Exams Tests, Genco,
What is the ratio of true power to apparent power in an ac circuit?
Why the capacitor bank is keeping on for electricity supply and keeping it off for generator supply
why a diode bridge is provided in vcb control circuit ?
There are two nos of 33Kv/11Kv 5MVA transformers conecting through HT cable from substation having metering at substation itself.One transformer used at a time another remains stand by.Further 11 nos of 11Kv/440V transformers are attached on it and each transformer is having its own Power factor correction panel.Now one 33/11Kv transformer at no load condition/Stand by condition is having power factor in leading side upto 0.21 and while when another tranformer at same situation have power factor in lagging 0.42. Now one thing is clear that transformer one is having 1.5 Km long 33kv cable due to that PF goes in leading side and another is having only 250 mtr length remains him lagging. Now i want to know that how i can maintain the Power factor at no load/ stand by position though both are behaving in seperate manner.
Formula to calculate fault current flowing in the neutral line?