I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.

0 Answers  

---

what will be the lap length of column reinforcement in case of welded lap

2 Answers  

---

Explain soil analysis?

0 Answers  

---

What are the common ways of demolition?

0 Answers  

---

What is the shelf life of a refractory used in boiler furnace ?

4 Answers   Monster,

---

How to decide the thickness of reinforcement concrete roof slab? what"s the thickness in inches the roof of 10'x10'? pls give me the answer and give the formula how to calculate it?

0 Answers   Jaypee,

---

How we can calaculate materials required for block work(1m3) block size 33cm x 20 cm x 17 cm, mortar 1:6

3 Answers  

---

how to determine H- zone in a column? where it will occur?

0 Answers  

---

what is the bearing capacity of hard rock

7 Answers  

---

Is 456 revised lastly in which year? & What are the revisions?

19 Answers   L&T,

---

A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals

0 Answers  

---

What is the requirement for over all CG of DG from the foundation surface to absorb the vibration of heavy set.

0 Answers   Eros, L&T,

---