What are the rules that must be kept in mind while designing castings?

0 Answers  

---

What is flash point

3 Answers   RRB,

---

What is the difference between conversion and enrichment ?

0 Answers  

---

Hi! Greetings of the day. Can somebody tell me about as built duct sheet area calculation method. As we know that for this purpose A = (W+H)*2*L. But I have query about multiplication factors for elbows, tappers, offsets etc if there is any. Also refer the papers if available. Please revert. Thanks in advance.

0 Answers  

---

What are the criterias for selecting piping for different utilities services like cooling water, DM Water, Service Water and Fire Water.Please provide some technical literature on that.

2 Answers   DAE,

---

---

what is bearing journal?

4 Answers   CPCL, SCCL,

---

What to write.. for perception about ntpc.. when you are applying for its interview?

0 Answers   NTPC,

---

What are all the possibilities discharge will be low in the pumps?

3 Answers   Infotech, UltraTech,

---

What type of cross-section is usually of a chisel?

0 Answers  

---

why we have to know the specific frequency of any equipment? does anybody know about specific frequency ?

3 Answers   ISRO,

---

What is the difference between pipe and tube?

6 Answers   Bhel, NTPC,

---

1. Centrifugal pump is used to drain the coolant from the machine to coolant tank via magnetic separator and paper filter. But more foam is raising in the coolant tank. We need to arrest the foam formation inside tank which is nt desired. How do we correct this issue? (Hardness of the water is at recommended ppm).

2 Answers   Nissan,

---