Answer / rajesh bejawada

1.due to improper setting gasket between two flanges.

2.design problem&manufacture failure.

3.lack of Alkylation paint in inner lining.

Answer / abhishek singh

Design Failure & lack of Alkylation paint in inner lining
system.

Answer / naresh

gasket do not proper setting and lack of inner lining.

Answer / sachin

due to improper setting gaskit between two flages

Answer / rajput

- difference between flange pcd & gasket size.
- sarrted face of flange not properly clean.

Is it the stress that, produces strain or strain produces stress?

1 Answers  

What is the use of white metal?

0 Answers   RRB,

What is the use of flash chamber in a vapour compression refrigeration cycle to improve the cop of refrigeration cycle ?

0 Answers  

Explain different types of fits.

0 Answers  

How the F.W.C. system of diesel engine circulate?

0 Answers   HPCL,

I want to model a piezoelectric beam in ansys software.How can I model the electrical circuit and how can I read the general current and voltage produced by the PZ?

0 Answers  

what is steam temperature measuring unit in steam turbine?

2 Answers  

How does the fuel suplly get control command as per the load variation in a DG Set.

3 Answers  

i require technical question paper which has been asked in last railway recruitment board exam for the post of junior engr.

0 Answers   RRB,

why are you looking for job change?

7 Answers   Corus,

I need BHEL Engineer Trainee written test papers in Mechanical stream.

0 Answers   Bhel,

What are the different types of brakes?

0 Answers