In closed loop control there are several “blocks” used to show the interac

In closed loop control there are several “blocks” used to
show the interactions between the process and the control
system. These blocks are referred to as the “process” and
the “controller.” Describe the relationship between these
two blocks when creating a well tuned control loop.

Question Posted / slyabi

1 Answers
4204 Views
I also Faced
E-Mail Answers

In closed loop control there are several “blocks” used to show the interactions between the pr..

Answer / tukaram

Controller: compare o/p with refferance i/p, manipulate & modify the actuating signal.
process:process the system in error free manner.

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

Why we are using temperature and pressure as a reference when measuring flow of steam?

4 Answers Shell,

the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove

0 Answers

plz... clarify my answer, how to calibrate vaccum (DP)leveltransmitter,it is hart. (digital).DETAILS:(coloumn)closedtank height 2650mm,and tx range is 0-1500mmH20.

2 Answers KNPC,

How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System

0 Answers

what is mean of 3 by 2 automation ?

5 Answers

What is the use of temperature compensation?

0 Answers

why we are using -24 vdc in plc?

1 Answers CGL,

What do you know about gail?

0 Answers GAIL,

We do have a problem in the company that is one PT connected to PlC which is mean 1 out of 1 in PLC system we do have the PAHH is 55 mbar and PALL 8 mbar with a timer of 15 sec for the PAHH the problem started when PAHH goes more than the set point which is 55 it reached up to 71 but due to timer doesn't trip . We force it and we checked everything nothing there . We replaced the transmitter problem still there the reading goes more than the 55 bar the range for transmitte is 0- 60 mbar . So we did loop check , aculaizing valve , wiring all are okay . What the possible causes for this ???

2 Answers National Petrochemical Company,

wht is mean by dpt(differential pressure transmitter)

1 Answers

How do understand by hart protocol?

4 Answers BW Instrumentation Electrical,

How to calculate the Range of level transmitter ?

1 Answers CPCL, Sejong, SSPL,

For more Instrumentation Interview Questions Click Here