WHAT IS THE DIFFERENCE BETWEEN A TRANSMITTER & A SMART TRANSMITTER.

8 Answers  

---

what is reset windup in integral control?

6 Answers   Honeywell,

---

What is the procedure of calibration of Load cell?

0 Answers  

---

What is the PLC configuration in Cement industry?

0 Answers   IMCO, Maha Cement,

---

what is Instrument Schedule, and what it is mainly used for?

0 Answers  

---

---

How can we say that accuracy of measurement increases by using 3 or 4 wire RTD? because for example: If resistance of RTD element is say r ohms and Resistance of the cable from transmitter to RTD is R ohms And if 4 wire RTD is used, ____._____________________ R ohms | |_____._____________________ R ohms / \ / r ohms \ \ | |______.__________________ R Ohms | |_______._________________ R ohms Then the actual resistance measured will be: Total = r + R/2 + R/2 = r +R Ohms Note: r+R instead of r ohms. hence error

2 Answers  

---

What is diffrent profibus & OFC Communication

1 Answers   Priya Cement,

---

Pls.could any one Clarify the following with an example. 1.At What condition Close on Rise and Close on Fall Pressure Switch contacts are used. 2.If Pressure is abnormal as per set pressure,if connecting Terminal of pressure switch breaks,how the voltage extends to Relay base. 3.Are these contacts come under fail safe philasaphy.

1 Answers  

---

HOW WE MEASURE A DRUM LEVEL BY DP TRANSMITTER ? WHAT IS ITS FORMULA ?

2 Answers   Thermax,

---

Where can i take training in intools software for Instrumentation design??

9 Answers  

---

what is the operation philosophy of proximity velocity sensor

1 Answers  

---

god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies

0 Answers  

---