Answer / nilesh

1.Ideal tapping location for liquid flow transmitter
orifice tapping in horizontal line is horizontalplane or 45
Degree downwards.
2.If tapping taken from top of the pipe then gases in
liquid service can disturb the measurement and hence
control.
3.Tamperory solution for fluctuation is frequent flushing.

what is the difference between attemperator and desuperheater ?

0 Answers  

---

What is DDC-MIS?

3 Answers  

---

Definition of level

3 Answers  

---

Dear all... I have 1 0-400 duplex type RTD, I connected the A side to the temperature indicator and B side to the PLC panel, but when I have observed then found that The PLC side temp has the variation. and it was distub to other RTD temp also. so what can I do.pls help me

1 Answers   Worley Parsons,

---

WHAT IS INSTRUMENTATION?

17 Answers   ITC Infotech,

---

---

What is the meaning of slope in PH transmeter?

1 Answers   Uttam Sugar,

---

if temperature transmitter is showing wran. sensor 2 fail how can you remove from the transmitter display m/n.3144p rosemount

3 Answers   Baumer,

---

ABB DCS (AC 800 M)redundency take howmany milliseconds to switch from master controller to slave?should be less than DCS scanning time?

2 Answers   SCS,

---

How to calibrate DP tramitter in flow measurement application? consider my range of flow is 0 to 2000 kg/hr ? please give calculation of , How much pressure applied on low pressure side and high pressure side please give detail of calculation .... It so important for me please reply as soon as possible

1 Answers  

---

how to measure low temperature(<100 dec celsisus) with non condact sensor

2 Answers  

---

What is instrumentation amplifier?

3 Answers  

---

What is difference between reset and initialization in industrial automation?

1 Answers   Marafiq,

---