Answer / k.prakashchandra

To name a few .1. wrong alignment 2. loose contact
3.insufficient lubrication 4. poor quality of materials
5.bolts and nuts properly tightened 6. over riding of blades

Explain what is Zener diode?

1 Answers  

---

What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?

0 Answers  

---

How to test and satisfy the conditions of the vector group YNd1 for power transformer?

1 Answers   Areva,

---

if the rotor of induction motor is purely inductive then what is the electromagnatic torque.........

1 Answers  

---

How to model "IF ELSE" statement in matlab simulink?

4 Answers  

---

how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?

0 Answers  

---

How can w select the cable size for different rating load & also waht r factors affecting the during selection of cable?

11 Answers   AB Inc, Bosch, BRB Cable, Lucas TVS, Trisome Technical Services,

---

what you mean ct ratio? why use 400/5a,200/5a,150/5a ?

1 Answers  

---

What are the conditions to be satisfied before connecting two DC generators in parallel?

9 Answers   Bhel, Godrej,

---

what are tpes of insulaors& its uses

1 Answers   ABC,

---

What is Reactance & Impedance? what is diffrence between these?

2 Answers  

---

How to check AC & DC Choke

1 Answers  

---