How is automatic reference junction compensation carried out in temperature recorders?

0 Answers  

---

How to calibrate Toxic gas detector?

0 Answers   Supertech,

---

when an eddy current probe is installed inside of a turbine or compressor in case of probe problem same as:crash of head of probe,changing the scale factor because of low measuring gap(physical gap is ok(example=1.14mm)but voltage is reduced(example=-6 volts),is any way to check the probe,when the ohm of probe is ok.thank you,(Karim Tavakoli)

1 Answers  

---

What is instrumentation measurement?

0 Answers  

---

WHICH INSTRUMENT USED TO CALIBRATE CONTROL VALVE?

23 Answers   Exxon Mobil, Honeywell,

---

why 8bit microprocessor referred as 2^16?

2 Answers  

---

Why thermo wells are used?

1 Answers  

---

where cn i find the previous years question paper for psu exam???????//

0 Answers  

---

In control valve there are two type of valve seat we can use metal to metal seat & soft seat.On this valve seat i have following doubt. 1)I have never seen practically the internal assembly of valve so my doubt is that basically weather the seat is soft seat or metal its basic MOC is same as valve body(SS or CS) only in soft seat we are using PTFE ring & place on valve seat & in metal this PTFE ring is not threr am i correct??????? 2)what are the common general rule for using metal to metal seat & soft seat,means its depend on process parameter like liquid,gas, steam & on valve leakage class.

1 Answers  

---

Can anybody tell me application of PLC,DCS,SCADA.

3 Answers   Reliance,

---

Hello-I know this not an engineering question,I am working in gulf & i want to do correspondence diploma in instrumentation,can any one give me the address of any university in which this courses are available.

2 Answers  

---

Lists Different types of Tappings.

4 Answers   TCS,

---