Interested to Buy Any Domain ? << Click Here >> for more details...
How to design the earth grid for lightning protection in an
industry
- 2 Answers
- 4686 Views
- I also Faced
- E-Mail Answers
Answer Posted / prakash soni
1)Several lightining arrester is used at the top of towers
lightning mast ,& buildings.
2)shild or ground wires are used above transmission line.
Gound wires are also used above & throughout the sub
station .
3)40mm or 32mm Ms rod are placed to entire area of plant
with wealding joints.
All lighting arresters and ground wires are connected
through the MS gried.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is value of earth resistance required for substation and equipment earthing and what are the reference guidelines
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
how we calculate electrical load on a building according to area?
how to flameproof electrical motor on the shaft?
How to know Resistance and Reactance value of main and aux winding of single phase capacitor start capacitor run induction motor to find capacitor value?
WHAT IS VCB SAFETY
Define branch?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
how to calculate IR value of 33KV cable ??
What is the reason for using a GE G101 MCB in place of an EP102 MCB if both are capable of AC circuit protection?
why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
What is the working principle of servo motor? And explain it.
volts=230 c=10mf a=??
